层状LiMnO_2的溶胶凝胶法合成及其改性

采用溶胶凝胶法合成了锂离子电池正极材料层状锰酸锂(o-L iMnO2),并对其进行了N i2+掺杂改性研究,优化了层状L iMnO2的合成路径及制备条件.采用XRD、充放电实验和交流阻抗测试方法研究了N i2+的掺入对o-L iMnO2充放电容量的影响.结果表明N i2+的掺入明显提高了锰酸锂的放电比容量和循环性能,抑制了循环过程中电池阻抗的增加.     

LiCaBO3的合成和LiBO2-CaO二元体系相图

某些无水硼酸盐具有熔点高、耐潮解、损伤阈值高、光学透过波段好等优点,在材料科学领域中一直受到人们的注视。陈创天等首次得到新型紫外倍频材料—低温相偏硼酸钡。之后,又合成了具有倍频效应的晶体材料α-LiCdBO_3。     

单斜层状LiMnO2的球磨-离子交换法合成及其电化学性能研究

通过球磨促进固相反应法合成出了具有单斜层状结构的前驱物NaMnO₂，随后通过离子交换得到了单斜层状LiMnO₂。XRD测试结果显示产物为单相。扫描电镜(SEM)和透射电镜(TEM)观测结果显示LiMnO₂的粒子尺寸为300～500 nm，HRTEM分析显示干扰条纹的间距为0.485 nm，基本对应于m-LiMnO₂的(001)晶面间距。红外吸收光谱(IR)和X射线光电子能谱(XPS)被用来测量m-LiMnO₂中Mn-O键的伸缩和弯曲振动吸收和Mn元素的价态。合成的m-LiMnO₂在电化学充放电循环初期表现了较好的电化学性能，但其循环寿命仍需要进一步改善。     

微乳液法合成LiFePO4 / C正极材料及其电化学性能

本文采用微乳液方法合成了纳米LiFePO₄ / C正极材料。制备样品分别用XRD和SEM进行表征，充放电测试其电化学性能。600 ℃制备样品为单一物相，平均粒径90 nm，在室温2.0～4.0 V (vs Li) 放电电压范围和15 mA·g^-1放电速率下，首次放电容量达到159 mAh·g^-1。制备样品同样展现良好的循环性能。在15 mA·g^-1速率下40次循环后，制备样品放电容量仍保持首次放电容量的98.9%。优异的电化学性能得益于样品颗粒的纳米尺寸、均匀分布以及表面碳层包覆提高了活性材料的电子电导率。     

Effect of lithium oxide dopants on electrophysical and sorption properties of zinc oxide

The effects of lithium oxide dopants (0.5–0.8 at. % Li) on the electrophysical and sorption properties of ZnO were studied in the temperature range from 150 °C to 410 °C. The introduction of lithium increases the activation energy of the conductivity of ZnO, decreases its conductivity, and increases the amount of S0₂ sorbed. Two forms of chemisorbed SO₂ (donor and acceptor) are observed on the surface.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1096–1100, May, 1996.     

冠醚B15C5萃取分离锂同位素的阴离子效应

本文研究了B15C5冠醚萃取锂盐时,不同阴离子对体系的同位素分离效应的影响。结果表明,阴离子在冠醚萃取过程中不仅对萃取络合物的稳定性有显著影响,而且阴离子半径及软度越大时,萃取体系的锂同位素分离系数(α_(LI))也越大。     

Li_3PO_4包覆LiMn_2O_4正极材料的结构表征和电化学性能

采用共沉淀法在尖晶石LiMn2O4颗粒表面包覆Li3PO4.XRD、SEM研究结果表明,包覆后的材料仍为尖晶石结构,粒径均匀.电化学性能测试表明,Li3PO4包覆层的存在,减少了正极材料与电解液的直接接触,抑制了高温下电解液对LiMn2O4材料的侵蚀,从而有效改善了高温下材料的循环性能.在40℃时,包覆样品的比容量衰减率都低于未包覆样品,其中包覆1%Li3PO4的样品的初始比容量为110.4mAh/g,50次循环后比容量为84.1mAh/g.     

Synthesis of New Lithium Ionic Conductor Thio-LISICON—Lithium Silicon Sulfides System

The new lithium ionic conductors, thio-LISICON (LIthium SuperIonic CONductor), were found in the ternary Li₂S-SiS₂-Al₂S₃ and Li₂S-SiS₂-P₂S₅ systems. Their structures of new materials, Li_4+xSi_1−xAl_xS₄ and Li_4−xSi_1−xP_xS₄ were determined by X-ray Rietveld analysis, and the electric and electrochemical properties were studied by electronic conductivity, ac conductivity and cyclic voltammogram measurements. The structure of the host material, Li₄SiS₄ is related to the γ-Li₃PO₄-type structure, and when the Li⁺ interstitials or Li⁺ vacancies were created by the partial substitutions of Al³⁺ or P⁵⁺ for Si⁴⁺, large increases in conductivity occur. The solid solution member x=0.6 in Li_4−xSi_1−xP_xS₄ showed high conductivity of 6.4×10^-4 S cm⁻¹ at 27°C with negligible electronic conductivity. The new solid solution, Li_4−xSi_1−xP_xS₄, also has high electrochemical stability up to ∼5 V vs Li at room temperature. All-solid-state lithium cells were investigated using the Li_3.4Si_0.4P_0.6S₄ electrolyte, LiCoO₂ cathode and In anode.     

3-Cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines in the synthesis of substituted 3-(aminomethyl)pyridines

The reactions of substituted 3-cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines with lithium aluminum hydride in anhydrous diethyl ether afforded the corresponding 3-aminomethyl derivatives, which were used in the synthesis of the corresponding amides.